Subject	Duh - didn't scroll over enough on the image, now I
Posted by	jzack on August 22, 2012 at 8:33 PM
	This message has been viewed 163 times.
In Reply To	um...ok, maybe it's not a scratch... posted by inf on August 21, 2012 at 09:44 PM
Message	see the issue. If filing doesn't work as posted above, maybe fill in with some JB Weld and then sand/file to get it shaped right?
Follow Ups	Scratched gasket surface on transmission front cover - inf 19:11:36 08/21/12 Not really sure on the issue - can you circle or highlight - jzack 20:27:50 08/21/12 um...ok, maybe it's not a scratch... - inf 21:44:33 08/21/12 Duh - didn't scroll over enough on the image, now I - jzack 20:33:49 08/22/12 It doesn't even go through, from outside to inside. - zellamay 23:49:14 08/21/12 the wire wheel actually smoothed it out a lot, but It... - inf 01:14:08 08/22/12 I'd still find a way to smooth out that surface. - zellamay 02:12:51 08/22/12 I'd really try to get a flat file up into that space. Even - Gordo 93TT Daytona 08:17:08 08/22/12 Yes. Hopefully, I'd have thought of that if I were on the - zellamay 11:20:00 08/22/12 I just fear the file will remove parts of the flat surface - inf 12:06:12 08/22/12 It's a matter of technique. Gently with a fine-tooth file. - zellamay 12:38:27 08/22/12 2nd. Use a light touch to take off the peaks. When you put - Gordo 93TT Daytona 14:06:01 08/22/12 The gasket doesn't go all the way to the bearing though - inf 01:17:05 08/22/12 I'm slow, I just got what you are saying here. Filing down - zellamay 08:40:01 08/23/12
Post a Followup	You cannot reply to this message because you are not logged in.