Subject	That wasn't my job. That was someone else's pics. (n/m)
Posted by	evan_aggie on August 21, 2012 at 9:55 AM
	This message has been viewed 251 times.
In Reply To	Re: Re: Does this RTV job look safe? posted by preprodigy on August 21, 2012 at 04:28 AM
Message
Follow Ups	Follow up to oil pan rtv: how do you keep from smearing it - evan_aggie 17:41:14 08/19/12 I'd completely remove the cross member - aliaZ 06:52:22 08/20/12 Wait, what? Remove cross member but swing the rack? - evan_aggie 08:06:20 08/20/12 Does this RTV job look safe? - evan_aggie 13:10:02 08/20/12 I put the bead in the middle where the grooves are. - Woody75 (Denver) 13:34:04 08/20/12 Don't see how it is possible w/ the cross member in place. - evan_aggie 15:49:25 08/20/12 2nd. Bead in the middle. Lighter on the seals. (n/m) - ConVerTT 09:41:01 08/21/12 Re: Does this RTV job look safe? - Tech@EPR 00:59:52 08/21/12 Re: Re: Does this RTV job look safe? - preprodigy 04:28:59 08/21/12 That wasn't my job. That was someone else's pics. (n/m) - evan_aggie 09:55:12 08/21/12 What did you mean: outside the bolt holes on both block and - evan_aggie 10:20:23 08/21/12 Every oem sealed pan I have removed has been in the middle. - Woody75 (Denver) 10:50:20 08/21/12
Post a Followup	You cannot reply to this message because you are not logged in.