Subject	Wait, what? Remove cross member but swing the rack?
Posted by	evan_aggie on August 20, 2012 at 8:06 AM
	This message has been viewed 666 times.
In Reply To	I'd completely remove the cross member posted by aliaZ on August 20, 2012 at 06:52 AM
Message	I'm not following you. You are saying to disconnect the tie rods, but do I leave the rack connected to the cross member? If so, I think I'd need to disconnect the fluid lines to the rack. Is that what you meant? Or did you mean separate the rack from the cross member? Also, most folks don't say you have to completely drop the cross member, so I don't know if I'm doing something wrong or what. I can see it being much easier if I didn't have AC or didn't have the transmission plate between the engine and tranny. Then I'd have an extra inch of room to work with and wouldn't have to pull and pry the cross member forward.
Follow Ups	Follow up to oil pan rtv: how do you keep from smearing it - evan_aggie 17:41:14 08/19/12 I'd completely remove the cross member - aliaZ 06:52:22 08/20/12 Wait, what? Remove cross member but swing the rack? - evan_aggie 08:06:20 08/20/12 Does this RTV job look safe? - evan_aggie 13:10:02 08/20/12 I put the bead in the middle where the grooves are. - Woody75 (Denver) 13:34:04 08/20/12 Don't see how it is possible w/ the cross member in place. - evan_aggie 15:49:25 08/20/12 2nd. Bead in the middle. Lighter on the seals. (n/m) - ConVerTT 09:41:01 08/21/12 Re: Does this RTV job look safe? - Tech@EPR 00:59:52 08/21/12 Re: Re: Does this RTV job look safe? - preprodigy 04:28:59 08/21/12 That wasn't my job. That was someone else's pics. (n/m) - evan_aggie 09:55:12 08/21/12 What did you mean: outside the bolt holes on both block and - evan_aggie 10:20:23 08/21/12 Every oem sealed pan I have removed has been in the middle. - Woody75 (Denver) 10:50:20 08/21/12
Post a Followup	You cannot reply to this message because you are not logged in.