Subject	I don't get a code for no solenoid
Posted by	BlackholeZ on August 08, 2012 at 12:58 AM
	This message has been viewed 118 times.
In Reply To	But he still has to worry about the EGR vacuum soleniod too. (n/m) posted by jzack on August 06, 2012 at 06:33 PM
Message	I removed the whole connector. -Dan BlackholeZ VTC Solenoid Caps Installation Procedure "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines "You're the Skrillex of Z32s." BradX (UF)
Follow Ups	can the egr valve be disabled............. - jjames69 21:15:10 08/05/12 Yes - solenoid (or resistor) has to be in place to keep - jzack 22:43:05 08/05/12 Most Z32's do not have an EGR temperature sensor anyway - Fast300 15:41:11 08/06/12 But he still has to worry about the EGR vacuum soleniod too. (n/m) - jzack 18:33:49 08/06/12 I don't get a code for no solenoid - BlackholeZ 00:58:08 08/08/12 2nd that. no code on solenoid unplugged (n/m) - Dane (Houston) 14:49:13 08/08/12 Not accomplishing much, pull plenum to do it right (n/m) - craigz96tt 07:58:45 08/06/12 Re: Not accomplishing much, pull plenum to do it right - jjames69 11:32:46 08/06/12 No. But you must remove the upper intake to cap it right (n/m) - craigz96tt 15:35:56 08/06/12 Yes, cut tubes do make the uppe plenum install easier... - jzack 18:32:25 08/06/12
Post a Followup	You cannot reply to this message because you are not logged in.