Subject	Yes, cut tubes do make the uppe plenum install easier...
Posted by	jzack on August 06, 2012 at 6:32 PM
	This message has been viewed 152 times.
In Reply To	Re: Not accomplishing much, pull plenum to do it right posted by jjames69 on August 06, 2012 at 11:32 AM
Message	but you'll still need to install something to block off the plenum openings too. Can be cut out of a simple piece of thin aluminum, RTV'd and then bolted down into place. Folks sell plates that do this too... Sorry - forgot to post this part in my response yesterday...
Follow Ups	can the egr valve be disabled............. - jjames69 21:15:10 08/05/12 Yes - solenoid (or resistor) has to be in place to keep - jzack 22:43:05 08/05/12 Most Z32's do not have an EGR temperature sensor anyway - Fast300 15:41:11 08/06/12 But he still has to worry about the EGR vacuum soleniod too. (n/m) - jzack 18:33:49 08/06/12 I don't get a code for no solenoid - BlackholeZ 00:58:08 08/08/12 2nd that. no code on solenoid unplugged (n/m) - Dane (Houston) 14:49:13 08/08/12 Not accomplishing much, pull plenum to do it right (n/m) - craigz96tt 07:58:45 08/06/12 Re: Not accomplishing much, pull plenum to do it right - jjames69 11:32:46 08/06/12 No. But you must remove the upper intake to cap it right (n/m) - craigz96tt 15:35:56 08/06/12 Yes, cut tubes do make the uppe plenum install easier... - jzack 18:32:25 08/06/12
Post a Followup	You cannot reply to this message because you are not logged in.