Subject	If you don't have one - a tranny jack is helpful for this
Posted by	jzack on August 04, 2012 at 10:28 AM
	This message has been viewed 207 times.
In Reply To	transmission removal posted by krunk24 on August 04, 2012 at 07:08 AM
Message	job too. The jack is helpful in lifting the tranny slightly so it can be pulled away from the engine. On the re-install, jacking the engine a little bit is helps to get the tranny aligned again. Once the tranny is disconnected - you'll notice the engine sits in the bay a little "off" since that weight is no longer connected. Jacking the engine (ie., floor jack and block of wood where tranny mounts to engine) helps solve this issue...
Follow Ups	transmission removal - krunk24 07:08:36 08/04/12 If you don't have one - a tranny jack is helpful for this - jzack 10:28:02 08/04/12 Disconnecting the throttle body hoses can allow - doug8867 14:22:36 08/04/12 Make sure the transmission is straight - Zinister1 17:19:27 08/04/12 Use FAQ section (n/m) - craigz96tt 07:51:21 08/06/12
Post a Followup	You cannot reply to this message because you are not logged in.