Subject	He is talking about using a timing light to make sure your
Posted by	JonnyZ(SoCal) on August 03, 2012 at 2:20 PM
	This message has been viewed 173 times.
In Reply To	Re: Before you changed the TB did you check the timing>> posted by syphon0202 on August 03, 2012 at 02:16 PM
Message	At 15 degrees. Also when you did the belt, did you count the cogs? Things can look good but it's easy to be off a tooth and still look like it's set properly.
Follow Ups	300zx idling poorly after some work - syphon0202 10:05:44 08/03/12 Re: 300zx idling poorly after some work - Stokens (StoMoZTT) 11:04:52 08/03/12 Re: Re: 300zx idling poorly after some work - syphon0202 12:28:31 08/03/12 Before you changed the TB did you check the timing>> - ZUL8TR 13:25:23 08/03/12 Re: Before you changed the TB did you check the timing>> - syphon0202 14:16:14 08/03/12 He is talking about using a timing light to make sure your - JonnyZ(SoCal) 14:20:20 08/03/12 Re: He is talking about using a timing light to make sure your - syphon0202 15:10:02 08/03/12 Sounds like it should be good as long as tensioner was set - JonnyZ(SoCal) 15:26:02 08/03/12 Re: Sounds like it should be good as long as tensioner was set - syphon0202 15:30:22 08/03/12 That should be fine. (n/m) - Summeronthechain (MN) 09:12:58 08/06/12 Claification: I mean using a timing light before the TB >> - ZUL8TR 06:47:42 08/04/12
Post a Followup	You cannot reply to this message because you are not logged in.