Subject	Thx for all the info. So are you saying that....
Posted by	mpmarino on July 15, 2012 at 12:13 PM
	This message has been viewed 703 times.
In Reply To	OEM system always regulates timing up to max RPM/max load posted by OverZealous (CT) on July 14, 2012 at 01:56 PM
Message	If there is a condition in which the RPMs are over 4500 (DET not actively monitoring) and the DET sensor goes open circuit; that the timing will immediately back off? I am planning a failsafe and this is very relevant and helpful, as I wasn't sure of the high RPM conditions in relation to the knock sensor failure (or faked failure). TIA! 8.5 to 1 CR NA. For the moment....
Follow Ups	Z32 Knock Control - Do you know your A,B,C's? - zromtech_ 22:41:38 07/13/12 OEM system always regulates timing up to max RPM/max load - OverZealous (CT) 13:56:15 07/14/12 Re: OEM system always regulates timing up to max RPM/max load - zromtech_ 14:49:01 07/14/12 Thx for all the info. So are you saying that.... - mpmarino 12:13:39 07/15/12 Re: Thx for all the info. So are you saying that.... - zromtech_ 12:20:06 07/15/12 Fantastic - Thanks. (n/m) - mpmarino 12:38:26 07/15/12 excellent information, thanks for sharing (n/m) - RobZ32 22:50:08 07/15/12 Re: excellent information, thanks for sharing - zromtech_ 13:18:53 07/17/12
Post a Followup	You cannot reply to this message because you are not logged in.