Subject	I've replaced motor mounts by supporting the motor
Posted by	ThunderZ on July 08, 2012 at 10:08 PM
	This message has been viewed 136 times.
In Reply To	Replacing the front suspension member.. Suggestions? posted by artomason on July 07, 2012 at 07:08 PM
Message	where it connects to the trans w/ a floor jack, using a piece of wood between the jack and the engine/trans. Just be careful not to dent the oil pan. Also needed 2 more jacks on the frame on both sides to raise/lower as needed while doing this job.
Follow Ups	Replacing the front suspension member.. Suggestions? - artomason 19:08:54 07/07/12 My recommendation would be to support it from the - jzack 23:28:49 07/07/12 I've replaced motor mounts by supporting the motor - ThunderZ 22:08:19 07/08/12 Re: I've replaced motor mounts by supporting the motor - artomason 15:52:45 07/09/12 That was the only way I could further raise the TT since - ThunderZ 21:26:15 07/09/12 Here you go - Woody75 (Denver) 23:13:57 07/08/12 yep the Woody method works awesome - aliaZ 06:37:18 07/10/12
Post a Followup	You cannot reply to this message because you are not logged in.