Subject	Pivot bolt won't back out, Doug.
Posted by	Stokens (StoMoZTT) on July 06, 2012 at 9:03 PM
	This message has been viewed 215 times.
In Reply To	Just unscrew the pivot bolt from the front then the posted by doug8867 on July 06, 2012 at 08:40 PM
Message	That's where I'm stuck. I'm actually using your write up now, which is awesome btw. The bolt just spins and spins. I can see that nut spinning too. I guess I could tape two wrenches together and try to reach it from underneath lol If I would have known addiction was this expensive I would have seen a shrink a long time ago. --BadZCar (FL)
Follow Ups	Alternator Pivot Bolt - Nut? - Stokens (StoMoZTT) 17:00:53 07/06/12 Re: Alternator Pivot Bolt - Nut? - Zinister1 19:01:11 07/06/12 I remember that I didn't put it back on. Once was enough - zellamay 19:23:39 07/06/12 Just unscrew the pivot bolt from the front then the - doug8867 20:40:04 07/06/12 Pivot bolt won't back out, Doug. - Stokens (StoMoZTT) 21:03:06 07/06/12 Based on what doug said, (I don't remember), maybe you - zellamay 22:47:35 07/06/12 I just noticed: that's what Zinister1 said to do also. (n/m) - zellamay 22:52:52 07/06/12 Thanks everyone. I'll give it a whirl tomorrow. - Stokens (StoMoZTT) 23:25:14 07/06/12 sometimes the tabbed nut has been replaced with a regular - aliaZ 10:05:05 07/07/12 I got it out of there... - Stokens (StoMoZTT) 16:42:56 07/07/12 I knew the original nut was replaced w/ a regular nut... - ThunderZ 22:14:51 07/07/12 2nd. You can use a regular nut temporarily or - doug8867 10:41:58 07/08/12
Post a Followup	You cannot reply to this message because you are not logged in.