Subject	Tap it towards the tranny to get it out of the lip it sits
Posted by	Xteam300TT (South Tx ) on July 04, 2012 at 11:14 PM
	This message has been viewed 151 times.
In Reply To	Pulling 1 piece aluminum drive shaft question??? posted by s1man711(CA) on July 04, 2012 at 02:04 PM
Message	in then drop it down alittle and slide it toward the back . Use a piece of wood and a hammer if you can to keep from damaging it with the hammer . iv had to get pretty aggressive with a few . good luck
Follow Ups	Pulling 1 piece aluminum drive shaft question??? - s1man711(CA) 14:04:59 07/04/12 Re: Pulling 1 piece aluminum drive shaft question??? - Zinister1 15:23:54 07/04/12 Re: Re: Pulling 1 piece aluminum drive shaft question??? - s1man711(CA) 16:15:26 07/04/12 Tap it towards the tranny to get it out of the lip it sits - Xteam300TT (South Tx ) 23:14:32 07/04/12 Re: Tap it towards the tranny to get it out of the lip it sits - Zinister1 23:31:30 07/04/12
Post a Followup	You cannot reply to this message because you are not logged in.