| Message |
I have done it once without, and it sucked BAD!! What I did was measure end of pressure plate fingers to the center of the disc. I did it in four sections at first, bottom of top finger to top part of the spline in disc, top part of bottom finger to bottom of spline in disc, left and right. Once all those are measured exactly the same, I pretty much measure in a clock formation, 1 oclock, 2 oclock, and so on. Once all were measure up correctly, then I gave it a shot. Took me three times lifting it up to finally get it in. In the three plus hours and many, many scared children from all my yelling, finally got it in. Or take an hour of of your day and save the headache, buy an alignment tool.
|
 |
01:30:03 07/01/12
