Subject	Soldering new injector connectors...
Posted by	JMartz on June 30, 2012 at 5:38 PM
	This message has been viewed 395 times.
In Reply To	Looking for electrical splice write-up posted by DrChoda on June 28, 2012 at 12:00 PM
Message	I did this job a few months ago. A bit tedious but not hard at all. Because the wires are short I was unable to use heat shrink tubing. I resorted to the less desireable electrical tape. I figure this would be a temopoarary job till I install my 1995TT engine harness.
Follow Ups	Looking for electrical splice write-up - DrChoda 12:00:10 06/28/12 I'd suggest using silver solder (comes in a thinner gauge) - Red Hawk (CO) 12:20:27 06/28/12 Great, thanks! (n/m) - DrChoda 13:15:50 06/28/12 Here is one tech w/ pics from Vorpalz - Gordo 93TT Daytona 12:19:42 06/30/12 Soldering new injector connectors... - JMartz 17:38:05 06/30/12
Post a Followup	You cannot reply to this message because you are not logged in.