Subject	Its already seperated by like an inch, but something feels
Posted by	TK3Z32(Wi) on June 28, 2012 at 4:51 PM
	This message has been viewed 147 times.
In Reply To	Tap the bell housing with a dead blow hammer. Its a little posted by Sleeper_TTZ(SeKy) on June 28, 2012 at 04:44 PM
Message	like its holding up. The indler shaft is slipping out, and the input shaft bearing is too, the thing thats not moving is that shifter shaft thing, even though I removed the pins.
Follow Ups	Splitting Tranny - TK3Z32(Wi) 16:17:33 06/28/12 Re: Splitting Tranny - Sleeper_TTZ(SeKy) 16:38:17 06/28/12 I did pull that out, although the ball must of dropped in - TK3Z32(Wi) 16:41:29 06/28/12 Tap the bell housing with a dead blow hammer. Its a little - Sleeper_TTZ(SeKy) 16:44:38 06/28/12 Its already seperated by like an inch, but something feels - TK3Z32(Wi) 16:51:39 06/28/12 Nvm got it apart - TK3Z32(Wi) 17:06:19 06/28/12
Post a Followup	You cannot reply to this message because you are not logged in.