Subject	Splitting Tranny
Posted by	TK3Z32(Wi) on June 28, 2012 at 4:17 PM
	This message has been viewed 190 times.
Message	I need to get my bellhousing off to get it machined, but I can not get the thing off for the life of me. I have the clips off the input shaft, idler shaft, and the shifter shaft. I aslo punched out the pins for the shifter under the black cover. Is there some sort of trick cause im smacking it as hard as I can and can only get it to split about an inch. Thanks.
Follow Ups	Splitting Tranny - TK3Z32(Wi) 16:17:33 06/28/12 Re: Splitting Tranny - Sleeper_TTZ(SeKy) 16:38:17 06/28/12 I did pull that out, although the ball must of dropped in - TK3Z32(Wi) 16:41:29 06/28/12 Tap the bell housing with a dead blow hammer. Its a little - Sleeper_TTZ(SeKy) 16:44:38 06/28/12 Its already seperated by like an inch, but something feels - TK3Z32(Wi) 16:51:39 06/28/12 Nvm got it apart - TK3Z32(Wi) 17:06:19 06/28/12
Post a Followup	You cannot reply to this message because you are not logged in.