Subject	trans plate, off??
Posted by	ouikikazz on June 25, 2012 at 3:47 PM
	This message has been viewed 286 times.
Message	went to put on the transmission plates on my engine (which is hard enough missing a dowel pin on the pass side block) but in any case went to line it up and the top 6 bolt holes are fine, the bottom 4, with the brackets that attach to block...do not, is that normal? (i don't think so) all those brackets are tightly secured really no wiggle room to adjust, its quite far off too...i lined up the big plate to the transmission and it lines up fine, so thinking i have an issue here??
Follow Ups	trans plate, off?? - ouikikazz 15:47:17 06/25/12 Try loosening the bolts where the brackets bolt to the block - Jayru 16:10:25 06/25/12 Correct. (n/m) - Bernie (NoVA) 16:11:23 06/25/12 Re: Try loosening the bolts where the brackets bolt to the block - ouikikazz 17:56:13 06/25/12 No problem! (n/m) - Jayru 18:07:40 06/25/12
Post a Followup	You cannot reply to this message because you are not logged in.