Subject	What temp gauge are you using ? If youre using the stocker
Posted by	Xteam300TT (South Tx ) on June 25, 2012 at 6:24 PM
	This message has been viewed 245 times.
In Reply To	It was 101 yesterday in Austin, but my gauge reads normal. posted by evan_aggie(ATX) on June 25, 2012 at 07:44 AM
Message	then normal will never be normal . After installing a FMIC my autometer temp gauge went from 190 to 216 , my stocker still read the same , normal ! FMIC off and Massives on , back to 190 ! :)
Follow Ups	controlling the z32 TT engine heat? - evan_aggie(ATX) 22:29:05 06/24/12 Re: controlling the z32 TT engine heat? - Krazyd27(Houston) 22:55:23 06/24/12 Re: Re: controlling the z32 TT engine heat? - elcid 23:01:04 06/24/12 First, make sure everything is right. It's hot in AZ, - zellamay 23:40:37 06/24/12 It was 101 yesterday in Austin, but my gauge reads normal. - evan_aggie(ATX) 07:44:07 06/25/12 Check out "Billion Highflow thermostat" posting today - zellamay 10:07:23 06/25/12 Put the undercovers back on and direct as much air as - Xteam300TT (South Tx ) 18:17:57 06/25/12 What temp gauge are you using ? If youre using the stocker - Xteam300TT (South Tx ) 18:24:34 06/25/12 Just a few suggestions - AsaHerring 00:36:27 06/25/12 Look up the Mod to run you aux fan on low setting often (n/m) - Red Hawk (CO) 13:30:05 06/25/12 I will, thanks! (n/m) - AsaHerring 18:44:19 06/25/12 Re: controlling the z32 TT engine heat? - MaxxAction 21:14:36 06/25/12 Re: Re: controlling the z32 TT engine heat? - elcid 21:40:06 06/25/12 Yes. You've got the assignment: design a system that works - zellamay 09:51:32 06/26/12 Re: Re: controlling the z32 TT engine heat? - pilikua 23:42:11 06/25/12 Doh. I've already done that. I guess it's just going to - evan_aggie(ATX) 08:07:00 06/26/12 I think that, in theory, dp's would help a little, due to - zellamay 09:58:07 06/26/12 P.S.: If you want dp's to help with under-hood temps, - zellamay 10:01:25 06/26/12 Mine are wrapped. Actually, some folks say wrapping the - evan_aggie(ATX) 16:22:13 06/26/12 Mine are wrapped. Actually, some folks say wrapping the - evan_aggie(ATX) 17:05:48 06/26/12
Post a Followup	You cannot reply to this message because you are not logged in.