Subject	thought back plates were just for refrence
Posted by	hellraz0r1337 on June 18, 2012 at 1:18 PM
	This message has been viewed 274 times.
In Reply To	1st thing I would do is double check all sensors/wiring posted by Summeronthechain (MN) on June 18, 2012 at 09:30 AM
Message	ok so i just read somewhere that even if the belt lines up on the cam gear timing marks but the back plate doesnt match the cam gears that you could run into trouble? i thought it was just belt to cam gears and crank gear to correctly time the z? i hate everyone's changing opinions lol........ OK well i guess im off a tooth on my drivers side from seeing that my 2 dots arent exactly equal passenger side intake cam dot is vertical and the drivers side intake cam dot is slightly behind vertical id say at a 12:55 type angle. BUT ALL THE COG COUNTS ADD UP.... WTF!? NO WONDER MY CARS RUNNING LIKE SHIT
Follow Ups	timing belt tension issue - hellraz0r1337 09:13:27 06/18/12 Re: timing belt tension issue - hellraz0r1337 09:26:27 06/18/12 1st thing I would do is double check all sensors/wiring - Summeronthechain (MN) 09:30:17 06/18/12 thought back plates were just for refrence - hellraz0r1337 13:18:34 06/18/12 Re: Re: timing belt tension issue - hellraz0r1337 09:34:03 06/18/12 Re: Re: Re: timing belt tension issue - MaxxAction 14:16:48 06/18/12 Re: Re: Re: Re: timing belt tension issue - hellraz0r1337 14:32:39 06/18/12 Re: Re: Re: Re: Re: timing belt tension issue - hellraz0r1337 14:43:35 06/18/12 Re: Re: Re: Re: Re: Re: timing belt tension issue - MaxxAction 19:52:16 06/18/12 not timing belt - hellraz0r1337 21:18:55 06/20/12
Post a Followup	You cannot reply to this message because you are not logged in.