Subject	yes it will bend enough to put the cover back on...
Posted by	doug8867 on June 17, 2012 at 6:57 AM
	This message has been viewed 117 times.
In Reply To	Exhaust valve covers. . . . posted by kentatwater on June 17, 2012 at 06:09 AM
Message	put back on EASILY... not so much. Make sure any brackets that hold the tube near the plenum have the bolt removed from the bracket so the tube can "bend" away from the plenum as far as possible when you pull it outward to insert the valve cover. I removed my EGR stuff so can't check my own car, but I believe there was a bracket near the back corner of pass. side plenum that I removed the bolt to if I recall. I think it was also almost impossible to put the bolt back in the bracket so it simply dangled from the tube after the valve cover replacement.
Follow Ups	Exhaust valve covers. . . . - kentatwater 06:09:11 06/17/12 yes it will bend enough to put the cover back on... - doug8867 06:57:40 06/17/12 Re: yes it will bend enough to put the cover back on... - kentatwater 07:47:37 06/17/12 Also - practice a few times putting it into place before - jzack 16:37:24 06/17/12 A few practice runs were in the plan - kentatwater 18:47:32 06/17/12
Post a Followup	You cannot reply to this message because you are not logged in.