Subject	Exhaust valve covers. . . .
Posted by	kentatwater on June 17, 2012 at 6:09 AM
	This message has been viewed 131 times.
Message	Working on my 95 NA. Intake valve covers a piece of cake with fresh gasket and rubber washers for the screws and torqued to 2.2 ft pounds. It was a pain to get the exhaust cover off on the passenger side. I gently pulled the EGR tube just enough out of the way to wiggle the cover out of there. Will it give or bend enough to get out of the way to put the cover back on easily? Or I guess I am asking, how far will it bend? Thanks in advance.
Follow Ups	Exhaust valve covers. . . . - kentatwater 06:09:11 06/17/12 yes it will bend enough to put the cover back on... - doug8867 06:57:40 06/17/12 Re: yes it will bend enough to put the cover back on... - kentatwater 07:47:37 06/17/12 Also - practice a few times putting it into place before - jzack 16:37:24 06/17/12 A few practice runs were in the plan - kentatwater 18:47:32 06/17/12
Post a Followup	You cannot reply to this message because you are not logged in.