Subject	Re: Re: Appears too tight. Not enough gap.
Posted by	hellraz0r1337 on June 15, 2012 at 3:58 PM
	This message has been viewed 144 times.
In Reply To	Re: Appears too tight. Not enough gap. posted by hellraz0r1337 on June 15, 2012 at 12:24 PM
Message	im a idiot i read the 4mm part but didnt read the pusher / tensioner arm. And my belt side wearage is page 16 of fsm improper installation of belt or improper cam gear plate installation. what are the chances i just ruined my new belt by rubbing the edges a little on the cam gear ?
Follow Ups	First time belt job - hellraz0r1337 10:10:30 06/15/12 Re: First time belt job - hellraz0r1337 10:20:57 06/15/12 Re: Re: First time belt job - hellraz0r1337 11:13:56 06/15/12 Should have 4mm after spinning it a few times. - Draker (Eugene, OR) 11:22:32 06/15/12 Re: Should have 4mm after spinning it a few times. - hellraz0r1337 11:33:48 06/15/12 Appears too tight. Not enough gap. (n/m) - Woody75 (Denver) 12:09:47 06/15/12 Re: Appears too tight. Not enough gap. - hellraz0r1337 12:24:40 06/15/12 Re: Re: Appears too tight. Not enough gap. - hellraz0r1337 15:58:27 06/15/12 None (IMHO) if the engine was only turned by hand.... (n/m) - jzack 17:32:22 06/15/12 None! Use make-shift tool that's 4mm thick 4 easy measuring. (n/m) - OverZealous (CT) 22:57:36 06/15/12 FYI: A 4mm hex key works nicely too. (n/m) - jzack 23:23:08 06/15/12 yep I do the same - aliaZ 10:15:12 06/17/12 Re: yep I do the same - hellraz0r1337 00:25:56 06/18/12
Post a Followup	You cannot reply to this message because you are not logged in.