Subject	Re: Appears too tight. Not enough gap.
Posted by	hellraz0r1337 on June 15, 2012 at 12:24 PM
	This message has been viewed 176 times.
In Reply To	Appears too tight. Not enough gap. (n/m) posted by Woody75 (Denver) on June 15, 2012 at 12:09 PM
Message	ok so its gap between arm and housing? fsm doesnt specify thank you. And i guess ill just redo my timing belt and put it centered on the cam gears again since i dont like the whole rubbing exhaust cam thing. Put the motor TDC and the cam dots will be facing upward just like the first time right?
Follow Ups	First time belt job - hellraz0r1337 10:10:30 06/15/12 Re: First time belt job - hellraz0r1337 10:20:57 06/15/12 Re: Re: First time belt job - hellraz0r1337 11:13:56 06/15/12 Should have 4mm after spinning it a few times. - Draker (Eugene, OR) 11:22:32 06/15/12 Re: Should have 4mm after spinning it a few times. - hellraz0r1337 11:33:48 06/15/12 Appears too tight. Not enough gap. (n/m) - Woody75 (Denver) 12:09:47 06/15/12 Re: Appears too tight. Not enough gap. - hellraz0r1337 12:24:40 06/15/12 Re: Re: Appears too tight. Not enough gap. - hellraz0r1337 15:58:27 06/15/12 None (IMHO) if the engine was only turned by hand.... (n/m) - jzack 17:32:22 06/15/12 None! Use make-shift tool that's 4mm thick 4 easy measuring. (n/m) - OverZealous (CT) 22:57:36 06/15/12 FYI: A 4mm hex key works nicely too. (n/m) - jzack 23:23:08 06/15/12 yep I do the same - aliaZ 10:15:12 06/17/12 Re: yep I do the same - hellraz0r1337 00:25:56 06/18/12
Post a Followup	You cannot reply to this message because you are not logged in.