Subject	nope... (n/m)
Posted by	Zski on June 15, 2012 at 11:33 AM
	This message has been viewed 109 times.
In Reply To	I'm guessing the self diag didn't tell you anything? (n/m) posted by Draker (Eugene, OR) on June 15, 2012 at 11:31 AM
Message
Follow Ups	Auto Trans Issues... Cant really figure it out. - Zski 08:31:58 06/15/12 I'm guessing the self diag didn't tell you anything? (n/m) - Draker (Eugene, OR) 11:31:05 06/15/12 nope... (n/m) - Zski 11:33:37 06/15/12 Sounds like you lost electronic signal to shift solenoids - Greg D. (Specialty-Z) 19:27:02 06/15/12 Thank you so very much Greg. - Zski 21:21:59 06/15/12 You must remove the ALC to run diagnostic (n/m) - Fast300 23:59:21 06/15/12 Ok, thank you didn't know that... (n/m) - Zski 06:25:40 06/16/12 Can the ALC fail? (n/m) - Zski 09:16:14 06/16/12 Yes, Anything can fail. (n/m) - Fast300 21:36:38 06/16/12 True, I just I should have better phrased my question. - Zski 06:09:11 06/17/12 Likeliness does not matter, - Fast300 00:36:35 06/18/12 Is the ALC a new install? Over tightening the connectors on - marklar182 13:12:28 06/17/12
Post a Followup	You cannot reply to this message because you are not logged in.