Subject	What is year and model of the Z? Early Z's had terrible>>
Posted by	ZUL8TR on June 12, 2012 at 8:16 AM
	This message has been viewed 285 times.
In Reply To	ok , i guess they're the smaller ones under the cover posted by jjames69 on June 11, 2012 at 10:02 PM
Message	connectors at the injectors that had a U shaped wire latch that is not that easy to remove. If that is the case use a sharp pick tool to pull out the U part way. To replace just put U all the way in and push on till snap. Careful old connectors can crack. If new style there is a tang to press to open the connector. In either case check for corrosion in connector and in the injector. Clean all corrosion and fill the connector wit dielectric grease before installing. Note also corrosion can be several inches up in the wires at the connectors. Not easy to detect unless cutting wires and replacing connectors. This happened to me and I had to cut out about 2 inches of wire before attaching the new type connectors. ZUL8TR in Orlando,FL
Follow Ups	injector ohm test. - jjames69 19:50:44 06/11/12 you must be reading coil packs, injectors have 2 prongs (n/m) - jlag 21:13:54 06/11/12 ok , i guess they're the smaller ones under the cover - jjames69 21:47:24 06/11/12 Only disadvantage to testing them that way -- no - jzack 23:09:03 06/11/12 ok , i guess they're the smaller ones under the cover - jjames69 22:02:14 06/11/12 What is year and model of the Z? Early Z's had terrible>> - ZUL8TR 08:16:53 06/12/12 its a 93. looks like you squeeze and they slide off - jjames69 09:10:57 06/12/12 We have you covered on replacement clips - Chuck@Z1 10:06:50 06/12/12 read 42 ohm on #4 - jjamez 11:20:45 06/12/12
Post a Followup	You cannot reply to this message because you are not logged in.