Subject	are you using the Dual POP with a dummy MAF or you using
Posted by	JoshE300zxTT on June 09, 2012 at 12:44 PM
	This message has been viewed 214 times.
In Reply To	MAF posted by SWAY5000 on June 08, 2012 at 11:50 PM
Message	using the SELIN? did you try search? This is how you check the Mass Air Flow Sensor: (From ALLDATADIY.com) Pull the rubber insulator back from the air flow meter connector. Turn the ignition switch ON. Using a volt meter, check voltage between terminal b and ground. Voltage should be approximately 0.8 vdc. Start and warm the engine to operating temperature and then idle it. Using a volt meter, check voltage between terminal b and ground. Voltage should be approximately 0.8 - 1.5 vdc. If the meter fails the above test, check the "hot wire" for dust or damage and replace the meter if necessary.
Follow Ups	MAF - SWAY5000 23:50:28 06/08/12 are you using the Dual POP with a dummy MAF or you using - JoshE300zxTT 12:44:59 06/09/12 Re: are you using the Dual POP with a dummy MAF or you using - SWAY5000 23:21:41 06/09/12 I used to work at autozone and I wouldnt trust their MAF. - michaell32 00:59:52 06/10/12
Post a Followup	You cannot reply to this message because you are not logged in.