Subject	Its easy...
Posted by	Red Hawk (CO) on June 08, 2012 at 3:16 PM
	This message has been viewed 171 times.
In Reply To	Upgrading clutch posted by krstull93 on June 08, 2012 at 02:08 PM
Message	When i did mine, I just put the clutch and fly on the shaft into the trans and you can see where it interferes and you just shave it down till you can slide them in. The shaving done is very minimal actually, and it is all right by the opening for the starter. As long as you have aluminum removal bits...its like a 5 minute job. TT BEAST IN PROGRESS!
Follow Ups	Upgrading clutch - krstull93 14:08:00 06/08/12 Its easy... - Red Hawk (CO) 15:16:34 06/08/12 Make sure you have a starter spacer as well. (n/m) - Lowfategg 15:22:21 06/08/12 Re: Make sure you have a starter spacer as well. - Chuck@Z1 15:27:12 06/08/12 Re: Make sure you have a starter spacer as well. - krstull93 15:42:14 06/08/12
Post a Followup	You cannot reply to this message because you are not logged in.