Subject	Subframe bushing question..
Posted by	inf on June 08, 2012 at 8:16 PM
	This message has been viewed 435 times.
Message	Is there another shell to remove? I noticed on the lower bushing side that this was the last step, but this one looks like there's another shell to remove...since it's not the lipped shell like the other one. All I had on the last one was the upper and shells and then the inner shell before the subframe shell. On another note, I noticed the upper and lower shells were actually attached like turbo inlet clamps are attached....I don't remember reading this...dunno though.
Follow Ups	Subframe bushing question.. - inf 20:16:27 06/08/12 Not to my knowledge. I just replaced all of the - weezee 21:14:46 06/08/12 Yes. - Bernie (NoVA) 21:20:34 06/08/12 Umm, I only removed the inner and the middle sleeves and the - tt_703 22:06:54 06/09/12 Nothing. The outer only comes out for solids. (n/m) - Woody75 (Denver) 10:07:43 06/10/12 also comes out for the new whiteline subframe bushings (n/m) - aliaZ 12:06:45 06/10/12 Depends what bushing you are putting in. - Woody75 (Denver) 00:36:23 06/09/12
Post a Followup	You cannot reply to this message because you are not logged in.