Subject	Re: Re: Re: And also wont require a plenum pull to change
Posted by	SammybTT(TN) on June 05, 2012 at 9:43 PM
	This message has been viewed 184 times.
In Reply To	Re: Re: And also wont require a plenum pull to change posted by SammybTT(TN) on June 04, 2012 at 09:27 PM
Message	Started my car up when I got home tonight and the slight ticking still existed and I was about to pull out of the garage it totally went away :). I proceeded to drive around about 20 miles and when I stopped to get gas I noticed that the ticking had started again. When I got home I am not sure if the noise was less or not but still not bearable to me. Any suggestions going forward? The oil and filter change currently has approximately 30 miles on it without any additives. Thanks,
Follow Ups	Noisy hydraulic lifter help after rebuild - SammybTT(TN) 10:23:58 06/03/12 Are you sure it's not the VTC Springs instead? (n/m) - ZTicket(Dallas) 13:30:29 06/03/12 Re: Are you sure it's not the VTC Springs instead? - SammybTT(TN) 20:26:10 06/03/12 Did you replace the intake cam gears with BDE's or new ones? (n/m) - ZXoltan 04:45:40 06/04/12 Re: Did you replace the intake cam gears with BDE's or new ones? - SammybTT(TN) 09:14:22 06/04/12 Re: Re: Did you replace the intake cam gears with BDE's or new ones? - SammybTT(TN) 09:19:51 06/04/12 And also wont require a plenum pull to change - ZXoltan 16:05:19 06/04/12 Re: And also wont require a plenum pull to change - SammybTT(TN) 18:22:37 06/04/12 Re: Re: And also wont require a plenum pull to change - SammybTT(TN) 21:27:32 06/04/12 Re: Re: Re: And also wont require a plenum pull to change - SammybTT(TN) 21:43:22 06/05/12 Re: Re: Re: And also wont require a plenum pull to change - SammybTT(TN) 22:47:44 06/05/12 Re: Re: Re: Re: And also wont require a plenum pull to change - SammybTT(TN) 19:41:34 06/10/12 Re: Re: Re: Re: And also wont require a plenum pull to change - SammybTT(TN) 20:35:09 06/10/12 Re: Re: Re: Did you replace the intake cam gears with BDE's or new ones? - SammybTT(TN) 22:10:31 06/06/12 Re: Re: Re: Re: Did you replace the intake cam gears with BDE's or new ones? - SammybTT(TN) 21:45:36 06/07/12 I would think a side by side comparison with a stethoscope - ZTicket(Dallas) 06:13:11 06/04/12 Re: I would think a side by side comparison with a stethoscope - SammybTT(TN) 09:15:21 06/04/12 Hope u get it figured out. Please report back when you do... (n/m) - ZXoltan 20:14:06 06/03/12 Re: Hope u get it figured out. Please report back when you do... - SammybTT(TN) 09:16:36 06/04/12
Post a Followup	You cannot reply to this message because you are not logged in.