Subject	Got it!! I did a search in the technical forum
Posted by	Markz (Tampa) on May 31, 2012 at 7:22 PM
	This message has been viewed 151 times.
In Reply To	I'm having problems getting my Koyo radiator in position!!!! posted by Markz (Tampa) on May 31, 2012 at 07:10 PM
Message	Someone suggested unbolting the intercooler piping on both sides of the radiator and pushing them to the side while sliding it down from above. One word.... Priceless!!!
Follow Ups	I'm having problems getting my Koyo radiator in position!!!! - Markz (Tampa) 19:10:19 05/31/12 Measure from pin to pin and measure from rad support - KongZTT GT28RS MD 19:15:17 05/31/12 Jack the front end up and insert it from the bottom. - z32z 19:16:30 05/31/12 Got it!! I did a search in the technical forum - Markz (Tampa) 19:22:24 05/31/12 Re: I'm having problems getting my Koyo radiator in position!!!! - MaxxAction 19:22:42 05/31/12 yes, that was the trick! (n/m) - Markz (Tampa) 19:23:19 05/31/12 Cut the stupid tabs off the side by the pins. - Joe@ZSpeedperformance 20:56:45 05/31/12 Re: Cut the stupid tabs off the side by the pins. - Devin300zx 23:05:52 05/31/12
Post a Followup	You cannot reply to this message because you are not logged in.