Subject	I relocated PTU and am using the loop as well.
Posted by	Coldfusown on May 31, 2012 at 11:18 PM
	This message has been viewed 139 times.
In Reply To	Re: To add: posted by MaxxAction on May 31, 2012 at 10:57 PM
Message	I'll give the wire to #1 a try tomorrow. It's just strange that wen cold the timing will appear fine and then warm jump what seems 20 degrees away from my mark. I'll update.
Follow Ups	Timing woes :( Please help. - Coldfusown 20:28:59 05/31/12 To add: - Coldfusown 20:40:45 05/31/12 Re: To add: - MaxxAction 22:57:19 05/31/12 I relocated PTU and am using the loop as well. - Coldfusown 23:18:10 05/31/12 Re: I relocated PTU and am using the loop as well. - MaxxAction 23:36:03 05/31/12 Once warmed up the coolant temp sensor OHM's in at - Coldfusown 23:57:03 05/31/12 I've been researching my symptoms - Coldfusown 00:14:50 06/01/12 Re: Once warmed up the coolant temp sensor OHM's in at - MaxxAction 07:19:13 06/01/12 I am just gonna pull the front of the motor off again - Coldfusown 19:11:04 06/01/12 Re: I am just gonna pull the front of the motor off again - MaxxAction 19:27:17 06/01/12 Could the electrical issue affect me getting the car to - Coldfusown 20:23:45 06/01/12 Re: Could the electrical issue affect me getting the car to - MaxxAction 21:00:00 06/01/12 UPDATE! - Coldfusown 21:55:47 06/01/12 On a FMIC... - Coldfusown 22:26:46 06/01/12 Re: On a FMIC... - MaxxAction 22:30:20 06/01/12 I'm stupid - Coldfusown 23:51:43 06/01/12 Re: I'm stupid - MaxxAction 06:45:13 06/02/12 I am using synthetic...this bad? (n/m) - Coldfusown 08:39:36 06/02/12 I've warmed it up twice to operating temp and drove - Coldfusown 09:19:20 06/02/12 Re: I've warmed it up twice to operating temp and drove - MaxxAction 12:43:37 06/02/12
Post a Followup	You cannot reply to this message because you are not logged in.