Subject	Re: Can't I get a CAS that actually works??
Posted by	Medallion Man on May 31, 2012 at 10:46 AM
	This message has been viewed 132 times.
In Reply To	Can't I get a CAS that actually works?? posted by MaxxAction on May 29, 2012 at 12:58 PM
Message	HI, just asking in case... have you cleaned out all around (in) the sprocket (shaft) where the CAS goes into the engine... I found a lot of dirt in there, it can cause pressure on the bearing in the CAS.
Follow Ups	Can't I get a CAS that actually works?? - MaxxAction 12:58:46 05/29/12 Should have just got a good used one from the get go. (n/m) - Woody75 (Denver) 13:10:06 05/29/12 Re: Can't I get a CAS that actually works?? - MaxxAction 13:33:07 05/29/12 sounds like your timing belt jumped - aliaZ 15:37:14 05/29/12 Re: sounds like your timing belt jumped - MaxxAction 15:55:37 05/29/12 ok (n/m) - aliaZ 16:54:00 05/29/12 Re: Can't I get a CAS that actually works?? - 94ttz32 16:07:13 05/29/12 Re: Re: Can't I get a CAS that actually works?? - MaxxAction 16:15:02 05/29/12 Re: Re: Re: Can't I get a CAS that actually works?? - 94ttz32 23:13:49 05/29/12 i ended up buying one of these - black&yellowttz 14:48:11 05/30/12 sorry here is the link - black&yellowttz 14:51:20 05/30/12 Re: sorry here is the link - MaxxAction 15:23:25 05/30/12 Re: Can't I get a CAS that actually works?? - Medallion Man 10:46:26 05/31/12 Re: Re: Can't I get a CAS that actually works?? - MaxxAction 18:27:44 05/31/12
Post a Followup	You cannot reply to this message because you are not logged in.