Subject	Re: Thanks all...
Posted by	Android300zx on May 31, 2012 at 8:48 AM
	This message has been viewed 116 times.
In Reply To	Thanks all... posted by beanz on May 28, 2012 at 06:51 PM
Message	That solder joint looks amazing. Good job. The PO of my Z hacked into the harness (twice) so I ended up ordering a brand new harness to not have to deal with issues. I was getting a misfire on one of the cylinders and the injectors and plugs are new as well as compression checking out. I'm assuming the hacked up harness was the issue. Keep practicing and you'll be an expert in no time.
Follow Ups	Does this solder joint look right? - beanz 16:34:08 05/28/12 looks good to me. - sandmanz32 16:46:13 05/28/12 Looks like a good solder job to me. (n/m) - MeatMan - 604Z.ca - 16:46:35 05/28/12 That looks correct. - michaell32 18:41:02 05/28/12 Thanks all... - beanz 18:51:31 05/28/12 Hopefully they de-pinned the connectors instead of cutting.. - MeatMan - 604Z.ca - 19:12:56 05/28/12 They cut the wires... - beanz 12:34:17 05/29/12 Re: Thanks all... - Android300zx 08:48:52 05/31/12 Looks good, just use pliers on the ends - EUGENE 23:53:50 05/28/12 looks good (n/m) - aliaZ 06:33:44 05/29/12 Perfect! (n/m) - JMartz 15:17:35 05/29/12 I'm a solder tech. I honestly have to say I am impressed!! (n/m) - TheSlimOne 20:43:39 05/30/12 Thanks! Though... - beanz 21:15:01 05/30/12 a little bit goes a long way. - TheSlimOne 16:45:59 05/31/12
Post a Followup	You cannot reply to this message because you are not logged in.