Subject	Thanks! Though...
Posted by	beanz on May 30, 2012 at 9:15 PM
	This message has been viewed 127 times.
In Reply To	I'm a solder tech. I honestly have to say I am impressed!! (n/m) posted by TheSlimOne on May 30, 2012 at 08:43 PM
Message	I think I probably allowed the joint to wick up too much solder. It looks really nice, but quite a bit of the wire under the insulation on either side of the joint was very hard. When I did the actual injector connector splices I basically followed the same procedure, but didn't use as much solder. Seems to have worked out fine, though the joints didn't look as saturated with solder as this one. Andy
Follow Ups	Does this solder joint look right? - beanz 16:34:08 05/28/12 looks good to me. - sandmanz32 16:46:13 05/28/12 Looks like a good solder job to me. (n/m) - MeatMan - 604Z.ca - 16:46:35 05/28/12 That looks correct. - michaell32 18:41:02 05/28/12 Thanks all... - beanz 18:51:31 05/28/12 Hopefully they de-pinned the connectors instead of cutting.. - MeatMan - 604Z.ca - 19:12:56 05/28/12 They cut the wires... - beanz 12:34:17 05/29/12 Re: Thanks all... - Android300zx 08:48:52 05/31/12 Looks good, just use pliers on the ends - EUGENE 23:53:50 05/28/12 looks good (n/m) - aliaZ 06:33:44 05/29/12 Perfect! (n/m) - JMartz 15:17:35 05/29/12 I'm a solder tech. I honestly have to say I am impressed!! (n/m) - TheSlimOne 20:43:39 05/30/12 Thanks! Though... - beanz 21:15:01 05/30/12 a little bit goes a long way. - TheSlimOne 16:45:59 05/31/12
Post a Followup	You cannot reply to this message because you are not logged in.