Subject	figure out which wire coming off the pump assembly
Posted by	WhiTTe Z on May 29, 2012 at 2:01 AM
	This message has been viewed 140 times.
In Reply To	I still have the stock TT pump should be fine for this setup (n/m) posted by timmaz on May 29, 2012 at 12:53 AM
Message	is the 12v and then ground the other. I believe it's a white wire on mine from the harness. You can make sure by testing the voltage. The pump itself will definitely be fine for this application. Out of curiosity why are you doing this swap? Did something happen to your TT motor?
Follow Ups	Fuel pump question - timmaz 19:22:00 05/27/12 The TT has a 3 speed pump/controller - WhiTTe Z 04:38:42 05/28/12 I have an Aeromotive FPR with a gauge that I can adjust. - timmaz 11:24:45 05/28/12 Yup should be two wires from the relay just - WhiTTe Z 23:21:33 05/28/12 I still have the stock TT pump should be fine for this setup (n/m) - timmaz 00:53:13 05/29/12 figure out which wire coming off the pump assembly - WhiTTe Z 02:01:29 05/29/12 I would just connect a wire from the relay - WhiTTe Z 17:33:10 05/29/12 I'm doing the swap because - timmaz 18:36:03 05/31/12
Post a Followup	You cannot reply to this message because you are not logged in.