Subject	Re: Re: issues with consult connector
Posted by	Medallion Man on May 27, 2012 at 1:44 AM
	This message has been viewed 293 times.
In Reply To	Re: issues with consult connector posted by Tanley on May 26, 2012 at 01:32 PM
Message	Hi and thanks…. I find this site has better pictures of the Service manual: [ http://z32.wikispaces.com/Factory+Service+Manual ] yeah, got all that and yes checked both earth points but that diagram doesn't show the other connectors on the loom or where the check wire goes to (fused & up behind the dash and to the clocks.... page EL9 connector M11.... I'm hoping someone has had a similar problem and fixed it... also can't explain why I don't get any power from the ecu block port 31 (power supply) cheers.
Follow Ups	issues with consult connector - Medallion Man 05:55:26 05/26/12 Re: issues with consult connector - Tanley 13:32:27 05/26/12 Re: Re: issues with consult connector - Medallion Man 01:44:47 05/27/12 Re: Re: Re: issues with consult connector - Tanley 20:03:22 05/28/12 Re: Re: Re: Re: issues with consult connector - Medallion Man 02:12:46 05/29/12 Re: Re: Re: Re: issues with consult connector - Medallion Man 03:30:59 05/30/12 Re: issues with consult connector - Tanley 05:47:16 05/30/12 Re: Re: issues with consult connector - Medallion Man 02:52:05 05/31/12 Re: issues with consult connector - Tanley 19:29:59 05/31/12
Post a Followup	You cannot reply to this message because you are not logged in.