Subject	nose panel gap adjustment
Posted by	evan_aggie(ATX) on May 25, 2012 at 8:07 AM
	This message has been viewed 695 times.
Message	I saw another post a while back about nose panel gap, and someone suggested just using a few washers at the front of the nose panel to push it back a little. However, the gap I see looks a bit more than even a washer would solve. Plus, I don't want to have a gap on the front side either. I made sure the gaps on the side are aligned. The front bumper is snug.
Follow Ups	nose panel gap adjustment - evan_aggie(ATX) 08:07:45 05/25/12 Are all your body panels and hood etc - 300ZMang 08:16:03 05/25/12 Good call. I'll check the rubber trip. I think it did come - evan_aggie(ATX) 08:28:30 05/25/12 Is radiator core support bent up under car? - Coldfusown 08:43:31 05/25/12 No, that I think is okay. But, I do think I could twist the - evan_aggie(ATX) 09:34:51 05/25/12 I had to washer-shim my aftermarket nose panel a bit. (n/m) - ZinnZ32 09:59:06 05/25/12
Post a Followup	You cannot reply to this message because you are not logged in.