Subject	If you do it that way you will have to extend every single
Posted by	JonnyZ(SoCal) on May 21, 2012 at 3:27 PM
	This message has been viewed 150 times.
In Reply To	Re: I have been finishing my swap using all jdm harnesses. posted by Android300zx on May 21, 2012 at 08:35 AM
Message	wire that connects to the ecu. I found that by hooking up the harness then dropping in the motor i was able to get most things connected without extension... However it did take a bit of work, and the harness is not exactly bolted to the firewall. I would only do this as a temp solution until you can afford the proper harness! I can take a few pics if that would help you, but I pretty much threw in the motor and extended the wires that weren't long enough... I also routed things my way and had to extend a few other things for a cleaner look.
Follow Ups	Using JDM TT harness in a 91 NA. Implications? - Android300zx 10:28:10 05/20/12 I have been finishing my swap using all jdm harnesses. - JonnyZ(SoCal) 12:30:40 05/20/12 Re: I have been finishing my swap using all jdm harnesses. - Android300zx 08:35:33 05/21/12 If you do it that way you will have to extend every single - JonnyZ(SoCal) 15:27:24 05/21/12 Re: If you do it that way you will have to extend every single - Android300zx 08:26:23 05/23/12
Post a Followup	You cannot reply to this message because you are not logged in.