Subject	Re: I appreciate your input...
Posted by	Tech@EPR on May 21, 2012 at 6:25 AM
	This message has been viewed 294 times.
In Reply To	I appreciate your input... posted by tiale11 on May 19, 2012 at 09:10 AM
Message	no matter what machine is used....you're wasting your time if you aren't utilizing a tq plate. Manual hone all the way to a new CK series from Sunnen...tq plates are a must. You can get away with running .005" piston to wall clearance (no its not excessive) just so long as all the bores are concentric and uniform to each other. Ep Racing | Create Your Badge
Follow Ups	Wiseco Piston-Bore Clearance - tiale11 21:06:29 05/18/12 I'd start over with another block and a new machine shop - aliaZ 07:02:22 05/19/12 I appreciate your input... - tiale11 09:10:03 05/19/12 Re: I appreciate your input... - Tech@EPR 06:25:31 05/21/12
Post a Followup	You cannot reply to this message because you are not logged in.