Subject	I appreciate your input...
Posted by	tiale11 on May 19, 2012 at 9:10 AM
	This message has been viewed 275 times.
In Reply To	I'd start over with another block and a new machine shop posted by aliaZ on May 19, 2012 at 07:02 AM
Message	Yes there are noticeable variations from cylinder to cylinder but each taper is up to spec. i'll start looking into getting a new block machined to Ash's specs then.
Follow Ups	Wiseco Piston-Bore Clearance - tiale11 21:06:29 05/18/12 I'd start over with another block and a new machine shop - aliaZ 07:02:22 05/19/12 I appreciate your input... - tiale11 09:10:03 05/19/12 Re: I appreciate your input... - Tech@EPR 06:25:31 05/21/12
Post a Followup	You cannot reply to this message because you are not logged in.