Subject	I'd start over with another block and a new machine shop
Posted by	aliaZ on May 19, 2012 at 7:02 AM
	This message has been viewed 322 times.
In Reply To	Wiseco Piston-Bore Clearance posted by tiale11 on May 18, 2012 at 09:06 PM
Message	I'd find a machine shop with a Sunnen SV-10 automatic cylinder hone or equivalent if you want perfectly round and taper free bores. Sounds like you have a lot of variation from cylinder to cylinder, and perhaps too much taper.
Follow Ups	Wiseco Piston-Bore Clearance - tiale11 21:06:29 05/18/12 I'd start over with another block and a new machine shop - aliaZ 07:02:22 05/19/12 I appreciate your input... - tiale11 09:10:03 05/19/12 Re: I appreciate your input... - Tech@EPR 06:25:31 05/21/12
Post a Followup	You cannot reply to this message because you are not logged in.