Subject	Injector problem
Posted by	gbeto on May 17, 2012 at 2:19 PM
	This message has been viewed 257 times.
Message	Im not done troubleshooting my Z after the rebuild, it sounds like a v8, I did a power test and the two front cylinders weren't working, replaced injectors and coils and still no go, now to check continuity on the cable what do I need? How do I check that the harness is sending signal?
Follow Ups	Injector problem - gbeto 14:19:07 05/17/12 Check continuity though the harness to the ECU. - Draker (Eugene, OR) 17:19:39 05/17/12 O-scope or Noid Lights - OverZealous (CT) 17:21:10 05/17/12 looking into this noid light. - gbeto 17:59:56 05/17/12 FYI - Just a simple LED with a resistor will let you run - jzack 22:28:51 05/17/12 Re: FYI - Just a simple LED with a resistor will let you run - gbeto 00:01:50 05/18/12 Pretty much any bright red LED will work along with a 1k or - jzack 21:00:31 05/18/12 100 or 4.7 - gbeto 13:17:39 05/19/12 Re: 100 or 4.7 - gbeto 13:20:51 05/19/12 Might be able to use AC Voltmeter if you get smart - OverZealous (CT) 17:25:21 05/17/12 no the wire. - gbeto 14:51:49 05/20/12 Check the PTU - OverZealous (CT) 20:27:28 05/21/12 i meant - gbeto 01:05:11 05/23/12
Post a Followup	You cannot reply to this message because you are not logged in.