Subject	Re: Why not just get the OEM mounts before it is all done?
Posted by	Lets_Go_Blues on May 16, 2012 at 11:45 AM
	This message has been viewed 97 times.
In Reply To	Why not just get the OEM mounts before it is all done? posted by rojoloco (VA Beach) on May 16, 2012 at 10:46 AM
Message	Ordered OEM mounts today. The water pipes look higher then others I've seen too, its a 95+ jdm engine going in a 90 and there have been a lot of little differences.. I'm pulling it out again
Follow Ups	engine fitment issues Pics inside - Lets_Go_Blues 17:31:00 05/15/12 Re: engine fitment issues Pics inside - sandmanz32 20:25:57 05/15/12 not trying to be a smart ass but did you bolt the trans up? - JoshE300zxTT 20:27:27 05/15/12 Re: not trying to be a smart ass but did you bolt the trans up? - Lets_Go_Blues 20:51:09 05/15/12 Why not just get the OEM mounts before it is all done? - rojoloco (VA Beach) 10:46:26 05/16/12 Re: Why not just get the OEM mounts before it is all done? - Lets_Go_Blues 11:45:21 05/16/12 Re: engine fitment issues Pics inside - WazTTed 21:25:57 05/16/12 Re: Re: engine fitment issues Pics inside - Lets_Go_Blues 00:51:59 05/17/12 I have done OEM, F150, and Delrin. All fit fine. - SkiFly01 15:38:22 05/17/12 and here is a shot of F150 mounts w/ heater hoses connected - SkiFly01 15:39:30 05/17/12 Re: and here is a shot of F150 mounts w/ heater hoses connected - Lets_Go_Blues 20:26:37 05/17/12 Re: Re: and here is a shot of F150 mounts w/ heater hoses connected - Lets_Go_Blues 12:49:22 05/18/12
Post a Followup	You cannot reply to this message because you are not logged in.