Subject	Re: Two different torque settings in FSM for pressure plate bolt
Posted by	Stadsport (PHX) on May 15, 2012 at 6:42 AM
	This message has been viewed 860 times.
In Reply To	Two different torque settings in FSM for pressure plate bolt posted by EUGENE on May 15, 2012 at 12:23 AM
Message	[ http://stadzport.com/FSM/CL_Clutch.pdf ] Later version of the manual, it looks like they outright omitted the second section. So, I'd probably go with the 25-33 ft-lb value.
Follow Ups	Two different torque settings in FSM for pressure plate bolt - EUGENE 00:23:25 05/15/12 Re: Two different torque settings in FSM for pressure plate bolt - Stadsport (PHX) 06:42:52 05/15/12 I used 25 -33lbs. Have had no problems. (n/m) - doug8867 07:58:16 05/15/12 Same here (n/m) - MR_X 15:50:20 05/15/12 I don't understand when they put a range for torque specs - fuzzymonkey 13:28:31 05/15/12 In the old days of analog torque wrenches it was - doug8867 14:14:47 05/15/12 THANKS DAD! For a torque wrench from the old days! (n/m) - fuzzymonkey 17:15:22 05/15/12 Eh, they're about $50 - $100 cheaper than a digital - doug8867 09:15:25 05/16/12
Post a Followup	You cannot reply to this message because you are not logged in.