Subject	That amount of lateral play is excessive. In and out is >>
Posted by	ZUL8TR on May 12, 2012 at 3:12 PM
	This message has been viewed 191 times.
In Reply To	Video: posted by Evan_Wright (Ca) on May 09, 2012 at 08:56 PM
Message	needed ours looks greater than it should be. Most likely the main drive bearing is going south and proper shimmimg is required. Replacing is not that easy if not familiar with the manual tranny innerds. Start with reviewing the Service manual on 5 speed service: [ http://300zx-twinturbo.com/cgi-bin/manual.cgi?list=mt&dir=&config=&refresh=&direction=forward&scale=0&cycle=off&slide=8&design=default&total=37 ] ZUL8TR in Orlando,FL
Follow Ups	Is it normal to have some play in the input shaft of the - Evan_Wright (Ca) 19:03:51 05/09/12 Video: - Evan_Wright (Ca) 20:56:44 05/09/12 That amount of lateral play is excessive. In and out is >> - ZUL8TR 15:12:29 05/12/12 PS what brand, type and grade gear oil are you using? >>> - ZUL8TR 15:15:18 05/12/12 Mine has a slight amount of play, way less than yours though - EUGENE 11:39:16 05/10/12 The more I search the more I think the input shaft bearing - Evan_Wright (Ca) 11:50:25 05/10/12 Mine did the same thing. - Drk93TT 21:22:22 05/10/12 mine sounds the same - aliaZ 07:15:35 05/11/12 Wow, that's is pretty bad. Maybe I shouldnt be complaining - Evan_Wright (Ca) 08:35:38 05/11/12 what was wrong with your input shaft? - aliaZ 21:08:22 05/12/12 end play is required for the transmission to rotate (n/m) - sandmanz32 19:00:33 05/10/12
Post a Followup	You cannot reply to this message because you are not logged in.