Subject	Re: Re: I doubt you have to use special wire
Posted by	EUGENE on May 10, 2012 at 12:00 PM
	This message has been viewed 226 times.
In Reply To	Re: I doubt you have to use special wire posted by 91FairladyTT on May 10, 2012 at 11:34 AM
Message	The EMI shield is just a bunch of stranded wire that's wrapped around an already sheathed signal wire. The EMI shield and the signal wire aren't physically connected to one another, so it shouldn't affect a continuity test. I've never tried running new cable for the detonation sensor, so I can't say for sure how important the EMI shielding is to its operation. But if it bothers you, just run new EMI shielded cable and attach the shield to a ground near the ECU.
Follow Ups	How can I rewire knock sensor from subharness plug to ECU?? - 91FairladyTT 11:09:51 05/10/12 I doubt you have to use special wire - EUGENE 11:26:35 05/10/12 Re: I doubt you have to use special wire - 91FairladyTT 11:34:58 05/10/12 Re: Re: I doubt you have to use special wire - EUGENE 12:00:18 05/10/12 Re: Re: Re: I doubt you have to use special wire - 91FairladyTT 12:38:13 05/10/12 Try this first - EUGENE 13:53:34 05/10/12 ^ this - fuzzymonkey 12:45:27 05/10/12 I thought I remembered reading there was an update - Draker (Eugene, OR) 13:04:24 05/10/12 Re: I thought I remembered reading there was an update - 91FairladyTT 13:51:09 05/10/12 Good luck! Let us know what works, I'm fighting a 34 too. (n/m) - Stokens (StoMoZTT) 14:22:08 05/10/12 The knock sensor circuit is very sensitive! - OverZealous (CT) 21:15:16 05/10/12 Re: The knock sensor circuit is very sensitive! - 91FairladyTT 09:44:03 05/11/12
Post a Followup	You cannot reply to this message because you are not logged in.