Subject	Aftermarket oil pressure gauge install question
Posted by	Matt300ZXT on May 09, 2012 at 11:42 PM
	This message has been viewed 2033 times.
Message	I'm interested in getting a couple gauges for my Z. One being boost of course, but I want to get an oil pressure one too. I'm looking at a few electrical ones and was curious what you guys do to install the sender. Are you removing the stock halfway inaccurate oil pressure sender and installing only the gauge's sender, or t-ing off and running both or what? I have seen some of those plates that seem to go onto the stock filter threading and offer 2 ports but that looks more like something I'd use to run an aftermarket oil cooler.
Follow Ups	Aftermarket oil pressure gauge install question - Matt300ZXT 23:42:15 05/09/12 Re: Aftermarket oil pressure gauge install question - lurker_nz 02:42:10 05/10/12 I used a Defi blue racer guage. - michaell32 05:02:45 05/10/12 Re: I used a Defi blue racer guage. - Matt300ZXT 12:35:37 05/10/12 FYI, Defi gauges in psi are not the same thread as the Z>> - my91z 17:24:07 05/10/12 What is the diam. and pitch for the stock BSPT fitting (n/m) - DE944 22:16:12 05/10/12 1/8" BSPT, same pitch as 1/8" NPT, as I recall. - my91z 06:34:00 05/12/12
Post a Followup	You cannot reply to this message because you are not logged in.