Subject	steering shaft into rack misalignment question
Posted by	AHos(Chicago) on May 08, 2012 at 8:51 PM
	This message has been viewed 175 times.
Message	During my build, I dropped my cross member for some reason. I however did not mark the position of the steering column into the rack. Now when I drive, the steering wheel is cocked slightly to the right when going straight. Makes for weird points where the turn signals will turn off (or wont stay on). I'm wondering if I can simply remove the steering wheel and line it back up or am I going to need to lower the cross member again and realign it that way, in order to get it straight and to get the turn signals turning off at the proper points?
Follow Ups	steering shaft into rack misalignment question - AHos(Chicago) 20:51:28 05/08/12 You should be able to remove and re-align where the - jzack 22:07:07 05/08/12 Is the knuckle where the splines are? - AHos(Chicago) 22:21:14 05/08/12
Post a Followup	You cannot reply to this message because you are not logged in.