Subject	If you are talking about the u-joint from the steering wheel
Posted by	BlackholeZ on May 05, 2012 at 2:23 AM
	This message has been viewed 126 times.
In Reply To	Additionally, does the steering "knuckle" with the two posted by Coldfusown on May 04, 2012 at 10:27 PM
Message	That only locates the rotational position of the steering wheel. You will probably have to tweak it once you get it aligned. That or the alignment shop can do it. -Dan BlackholeZ VTC Solenoid Caps and Installation Procedure "Capitalization is the difference between helping your Uncle Jack off a horse, and helping your uncle jack off a horse." "'she' also likes to swap since I think I am going to need to give her to woody again." - Dvlhntr "full alphabetic boost mode" - ChristopherTheOne "Two oil eating, angry, spinning triangles of death." - turtleboy on rotary engines " You're the Skrillex of Z32s." BradX (UF)
Follow Ups	Steering rack installed, check...but ? - Coldfusown 22:23:46 05/04/12 Additionally, does the steering "knuckle" with the two - Coldfusown 22:27:59 05/04/12 If you are talking about the u-joint from the steering wheel - BlackholeZ 02:23:16 05/05/12 For bleeding - recommended way is to get the front - jzack 22:58:10 05/04/12 Thank you, advice on the knuckle position? (n/m) - Coldfusown 23:07:36 05/04/12 This is how I did it, with holding it at each lock. - AHos(Chicago) 12:39:22 05/05/12 Also, don't fill the reservoir to the top before this, big - boileralum 12:53:09 05/05/12 Okay, thank you as that is just the info I was looking for! (n/m) - Coldfusown 16:03:54 05/05/12
Post a Followup	You cannot reply to this message because you are not logged in.