Subject	Dead cylinder problems...
Posted by	ZX NAT on May 06, 2012 at 5:20 PM
	This message has been viewed 187 times.
Message	My 4 and 5 cylinders are dead. New injectors, tested ohm reading. Coil packs are good, tested voltage and did the old swap test to be sure. Pulled ptu plugs and cleaned. Tried to do the cas turn check but couldnt hear any clicking from any of the 6 injectors. The cylinders worked before i changed the plenum gasket and bypassed the plenum cooling lines since i replaced the injectors and ran it shortly before pulling it again. Is there something i missed? Ran ecu codes and came up clean. Could the ptu be bad on those lines only? The car was sitting for the winter outside. Maybe the ecu itself? Any suggestions on where to go from here? 1993 Manual N/A Cherry Red Pearl 1997 Dodge Ram 1500 5.9 Magnum with 7 inch lift and 36's plus more...
Follow Ups	Dead cylinder problems... - ZX NAT 17:20:50 05/06/12 Yes cap the return line from the fuel rail and - njz 19:43:30 05/06/12 Thanks, I'll give that a try. (n/m) - Jinjiro 21:11:47 05/06/12 Do you use air or fuel for the pressure test? (n/m) - HK'S Z 16:41:48 05/08/12 Sorry ment to the fuel injector issue below (n/m) - njz 19:52:09 05/06/12 I can think of two things that could cause your issues: - Haasz32 10:46:27 05/07/12
Post a Followup	You cannot reply to this message because you are not logged in.