Subject	Re: Here's an idea.
Posted by	Dawei on May 04, 2012 at 6:52 PM
	This message has been viewed 110 times.
In Reply To	Here's an idea. posted by Draker (Eugene, OR) on May 04, 2012 at 03:44 PM
Message	Well, never done one before had no idea how to. Researched, now I know how to, buying the tool now. Any suggestions as to how to make sure each cylinder is at TDC before I test it? That's the only part I could not find.
Follow Ups	Is this possible: - Dawei 14:39:44 05/04/12 Re: Is this possible: - Dawei 14:42:12 05/04/12 Here's an idea. - Draker (Eugene, OR) 15:44:22 05/04/12 Re: Here's an idea. - Dawei 18:52:13 05/04/12 What I like to do is use a wooden dowel - Draker (Eugene, OR) 19:03:39 05/04/12 Re: What I like to do is use a wooden dowel - Dawei 04:12:40 05/05/12 Put a socket on the crankshaft and turn it with a wrench. (n/m) - Draker (Eugene, OR) 12:09:08 05/05/12 Re: Put a socket on the crankshaft and turn it with a wrench. - Dawei 16:22:43 05/05/12 There is a small lower portion of the shroud that comes off - my91z 17:59:41 05/05/12 Re: There is a small lower portion of the shroud that comes off - Dawei 19:41:16 05/05/12 Re: There is a small lower portion of the shroud that comes off - Dawei 19:41:34 05/05/12
Post a Followup	You cannot reply to this message because you are not logged in.